Parts Washing System – 4 Stage Conveyor

Assembly of the base frame for the 4 stage parts washer.

Attaching the Washer Frames to the Base Frame.

Installing and assembling the heating element into the washer tanks.

This is an overview of the washer tank frames.

Assembling the washer frame and housing for the conveyor belt.

This is the exhaust duct system that will go on the top of the washer and cycle the clean filtered air out of the customer's facility.

This shows the conveyor belt being laid out and prepared for installation.

This shows the side of the washer where the heaters and piping system have been installed.

This shows a few rows of the spray nozzles located within the wash and rinse cycles of the part washer.

This shows the loading end of the conveyor along with the multiple filters needed to keep the wash and rinse water clean.

This shows the washer completely painted with only a few more parts needing to be assembled.

This shows the washer all packaged up and waiting to be loaded onto the truck to ship to the customer.

This shows the washer loaded on a truck, leaving our facility and heading to the customer's.

This shows the discharge end of the finalized Parts Washing System.

Final Installation and programming at customer's facility.

This shows parts running through and unloading parts at the customer's facility.